首页 > 研磨液 > Basic Knowledge of Grinding Wheel
Basic Knowledge Of Grinding Wheel
Basic Knowledge Of Grinding Wheel
abrasive grains of grinding wheels

Identification system of diamond & cbn wheels
Abrasive Type Mesh Size Hardness of Bond Concentration Bond Type Depth of Super Abrasive Section
D: Natural Diamond
SD: Synthetic Diamond
SDC: Coated Synthetic Diamond
cBN: Cubic Boron Nitride
cBNC: Coated Cubic Boron Nitride
16 100 400
18 120 600
20 140 800
30 170 1000
40 200 1500
50 230 2000
60 270 2500
80 325 3000
J Softer 


N Medium


R Harder
25  Lower
200  Higher
B: Resin
V: Vitrified
M: Metal
P: Electroplated
1.5 mm
2.0 mm
3.0 mm
5.0 mm
Grit size 
Diamond and CBN grit are available in many sizes and types.  The grit size is dependent upon the desired surface finish. In addition, the grit size also has an important effect on the grinding behaviour of the wheel. 
As far as the grit size is concerned, More SuperHard diamond complies with the FEPA standard.
Grit Rough Grinding Finish Grinding Fine Grinding Lapping
Diamond D181 - D151 D126 - D91 D64 - D46 D30 - D15
CBN B151 B126 B91 B46

The content of diamond or CBN in the grinding rim is heavily dependent upon the application. Generally, where rapid stock removal of tungsten carbide or hardened steel is intended, a concentration of 75 to 125 is selected. When a good surface finish is demanded, lower concentrations in combination with finer diamond or CBN powder are required. Concentrations of up to 150 are used for profile grinding wheels and cylindrical wheels which have a small contact area. 
Degree of Concentration Grain Content ct/cm³
200 8.8
175 7.7
150 6.6
125 5.5
100 4.4
75 3.3
50 2.2
25 1.1

Hardness Structure
hardness of grinding wheels

The hardness of a CBN or diamond grinding wheel is identified by a letter after the grit size. Superabrasive however, do not cover the total range found in conventional wheels i.e. very soft A to very hard Z.
The hardness of resin bonded superabrasive is defined as follows:
hardness of grinding wheels
Vitrified bonded wheels lie mainly in the hardness range from M to maximum R.
Harder specifications for 
► Long chip materials
► Narrow width of diamond & cbn layer
► Grinding where highly effective coolant used

Softer specification for
► Short - chip materials
► Wider layer of diamond & cbn
► Dry grinding or low concentration soluble
► Fine grit sizes
Material Processed by Diamond or cBN Wheel
Material Processed by Diamond or cBN Wheel
Basic shape of grinding wheel
The standard code employs a series of numbers and letters to designate the shape of a diamond wheel. Its use involves four simple steps shown at right. In this example, the complete grinding wheel shape number would read: 6A2C
6a2c diamond cup wheel
6a2c diamond cup wheel
6a2c diamond cup wheel
Copyright © 2003-2021 磨澳超硬材料有限公司 豫ICP备14005009号-4